Stiga Stig-A 1500 Instruction Manual page 48

Procedure:
1. Press the "STOP" button (A) to open the cover (B) and access the control console (C).
2. Press the "MODE SELECT" button (F) until the icons of the functions you wish to activate fl ash. The
icons relating to the selected functions fl ash.
3. Press the "CONFIRM" push button (G). The icons of the selected functions light up steadily to confi rm
the action.
4. Close the cover (B).
5. The robot lawn mower will start working according to the set mode.
NOTE: If after pressing the "CONFIRM" button (G), the "SELECT MODE" button (F) is pressed,
the icons for the selected functions will start fl ashing again, requesting to confi rm the newly
selected function. Press the "CONFIRM" button (G). The icons return to a steady light.
NOTE: If the cover (B) is opened, either during work or with the robot in the base, the icons
relating to the selected functions will fl ash, to indicate that it is necessary to confi rm the
operation before closing the cover again. If the cover is closed without pressing the "CONFIRM"
button (G), the robot will not perform any task until a new command is given by the user.
NOTE: If the robot battery is low, the battery icon fl ashes red to indicate that the selected action
cannot be performed.
NOTE: NOTE: the robot lawn mower only starts after closing the cover (B).
NOTE: The robot lawn mower goes to the charging base with the cutting device switched off .
A
C D
NOTE: If after pressing the "CONFIRM" button (G), the " SELECT MODE" button (F) is pressed,
the icons for the selected functions will start fl ashing again, requesting confi rmation of the newly
selected function. Press the "CONFIRM" button (G). The icons will once again light up with a
steady glow.
NOTE: if the cover (B) is opened, either during work or with the robot in the base, the icons
relating to the selected functions will fl ash, to indicate that it is necessary to confi rm the
operation before closing the cover again. If the cover is closed without pressing the The
"CONFIRM" button (G), the robot will not perform any operation until a new command is given
by the user.
44
5. OPERATION
B
I
E F
L
G
EN