Stiga PARK 4WD PRO 25 Instructions For Use Manual

Stiga PARK 4WD PRO 25 Instructions For Use Manual

Hide thumbs Also See for PARK 4WD PRO 25:

Advertisement

BRUKSANVISNING
KÄYTTÖOHJEET
BRUGSANVISNING
BRUKSANVISNING
GEBRAUCHSANWEISUNG
INSTRUCTIONS FOR USE
MODE D'EMPLOI
GEBRUIKSAANWIJZING
S T I G A P A R K
SV .... 8
FI ... 19
DA ..30
NO .41
DE...52
EN...64
FR....75
NL...86
8211-0540-02
4WD
P R O 2 5
P R O 2 0
P R O 1 6
P R O S v a n

Advertisement

Table of Contents
loading

Summary of Contents for Stiga PARK 4WD PRO 25

  • Page 1 S T I G A P A R K P R O 2 5 P R O 2 0 P R O 1 6 P R O S v a n BRUKSANVISNING SV ..8 KÄYTTÖOHJEET FI ... 19 BRUGSANVISNING DA ..30 BRUKSANVISNING NO .41...
  • Page 2 Pro16 Pro20 Pro25 Pro Svan J K L...
  • Page 3 Pro16 Pro20 Pro25 Pro Svan Pro25...
  • Page 4 10 Ampere Pro25 Pro16 Pro20 Pro16 Pro20 Pro Svan...
  • Page 5 Pro25...
  • Page 6 Pro16 Pro20 Pro25 Pro Svan...
  • Page 8 ENGLISH 1 GENERAL 2 DESCRIPTION This symbol indicates WARNING. Seri- 2.1 Drive ous personal injury and/or damage to The machine has 4-wheel drive. The power from property may result if the instructions the engine to the drive wheels is transferred hy- are not followed carefully.
  • Page 9 ENGLISH 2.4.5 Driving-service brake (3:F) • Lifting. Press the rear part of the switch until the implement is in its highest position (trans- The pedal (3:F) determines the gearing ratio be- port position). Then release the switch and the tween the engine and the drive wheels (= the height is locked in transport position.
  • Page 10 ENGLISH 2.4.14Rear Rake (5:L) Do not leave the machine with the key in position 2 or 3. There is a fire risk, (Pro20, Pro25, Pro Svan) fuel can run into the engine through the The machine is fitted with a control for electrical carburettor, and there is a risk of the adjustment of a rear rake (available as an battery being discharged and damaged.
  • Page 11: Areas Of Use

    NOTE! Ordinary lead-free petrol is a perishable The machine may only be used for the following and must not be stored for more than 30 days. tasks using the genuine STIGA accessories stated. Environmental petrol can be used, i.e. alkylate Work Accessories, STIGA genuine petrol.
  • Page 12: Safety Checks

    ENGLISH The oil level must never exceed the “FULL” mark. Status Action Result This results in the engine overheating. If the oil Cruise control acti- The driver gets up The cruise level exceeds the “FULL” mark, the oil must be vated.
  • Page 13: Maintenance

    This section contains tables covering the different • Do not spray water directly at the engine. engines that are included in STIGA’s Pro range. To • Clean the engine with a brush and/or com- facilitate reading, mark the data that applies to the pressed air.
  • Page 14 ENGLISH 5.4.1 Change intervals The engine oil may be very hot if it is drained off directly after the engine is The table below states hours of operation and cal- shut off. Therefore allow the engine to endar months. Carry out the relevant action at cool a few minutes before draining the whichever occurs first.
  • Page 15: Fuel Filter

    ENGLISH 6. Install the filter. First screw in the filter so that 8. Draw out the oil from the deeper section of the the gasket comes into contact with the engine. reservoir using an oil extractor. See fig. 20. Then screw in the filter a further 2/3-1 turn. 9.
  • Page 16: Belt Transmissions

    ENGLISH 10.Drive the machine 8-10 metres forwards and 8- 1. Install the battery in the machine as shown be- 10 metres backwards. If the machine has hy- low. draulic power assisted steering, apply full steer- 2. Place the machine outdoors or install an extrac- ing lock at the same time.
  • Page 17: Air Filter, Engine

    ENGLISH 1. Place the petrol tank on the brackets. Check that 4. Wash the pre-filter (27:C) in liquid detergent the petrol hose is not touching the hydraulic and water. Squeeze dry. Pour a little oil on the pump. filter and squeeze in the oil. 2.
  • Page 18 ENGLISH 5.13 Lubrication 6 PATENT - DESIGN REGISTRA- All lubrication points in accordance with the table TION below must be lubricated every 50 hours of opera- tion as well as after every wash. This machine or parts thereof is covered by the fol- Object Action Fig-...
  • Page 19 w w w. s t i g a . c o m GGP Sweden AB · Box 1006 · SE-573 28 T RANÅ S...

Table of Contents