Stiga Stig-A 1500 Instruction Manual page 59

The working area is not
mowed completely.
The charging base light
does not turn on when
the robot is out of the
charging base.
The charging base light
flashes.
The warning icon is on
on the keyboard
The robot lawn mower
stops temporarily in the
work area.
EN
Insufficient working hours.
Cutting device with encrustations
and / or residues.
Pivoting cutting blades blocked by
encrustations or residues.
The working area is too large for
the robot lawn mower's capacity.
Batteries about to exhaust their
life cycle.
Batteries are not charged
completely.
The supply voltage is missing
or there is a fault in the charging
base.
There is a fault in the charging
base.
It indicates Fault / Failure
conditions.
Weak GPS signal
Extend working hours
Switch off the robot lawn mower in safety
conditions (See Par. 2.3). Clean the
cutting device.
Switch off the robot lawn mower in safety
conditions (See Par. 2.3). Replace the
cutting blades.
Reduce the work area (see Technical
Data Par. 1.2).
Replace the batteries with original spare
parts (See Par. 6.4).
Clean and eliminate any oxidation
from the contact points (See Par. 6.2).
Recharge the batteries.
Check that the power supply unit is
plugged in correctly.
Check the integrity of the power supply
connection cable.
Turn off the charging base and turn it on
again after a few minutes. If the problem
persists, contact a service centre.
See the app for more information or
contact a service centre.
If the problem persists, contact an
authorized dealer.
7. TROUBLESHOOTING
(See Par. 4.7.12).
55