Stiga Stig-A 1500 Instruction Manual page 32

Requirements and obligations:
• Satellite reference station (A).
• Power adapter (F) (purchased separately).
• Fixing bracket (E).
• Screws for fastening the satellite reference station to the bracket (G).
• U-bolt for fastening the bracket to pole (H) or screws for wall mounting (not included).
Requirements and obligations:
1. Check the installation requirements in Par. 4.3.2.
2. Open cover (B).
3. Disconnect connector (C) of satellite reference station (A) from charging base (D).
4. Unscrew the fi xing screws (I) and pull out the satellite reference station (A) from the charging base
(D).
5. Fasten the bracket (E) to a wall (M) using the fi xing screws (not included), making sure it is level.
When mounting the unit on a pole (L), use the included U-bolt (H) to fasten the bracket (E).
6. Fasten the satellite reference station (A) to the bracket (E) with connector (C) facing down using
screws (G). Make sure the station is in a horizontal position. Install the station at least 2.5 meters
above the ground.
7. Connect the satellite reference station to the power supply (F) using the connector (C) and tighten
the ring nut.
8. Secure the power cable to prevent it from being damaged or posing a safety hazard.
9. Connect the power supply plug (F) to the electrical outlet.
NOTE: The top part of the satellite reference station should be as close as possible to the top of
the wall or the pole.
C
28
4. INSTALLATION
L
E
G
A
H
M
C
E
F
EN