Table of Contents
Advertisement
[NATIVE]
[SIDE BY SIDE]
[TOP AND BOTTOM]
[FRAME SEQUENTIAL]
*1 Excluding when SDI is input
*2 Only when progressive signals with the vertical scanning frequency of 103.9 Hz or 120 Hz are input to the following inputs
HDMI/DVI-D/DIGITAL LINK/DisplayPort
4)
Press the <执行> button.
Note
f When [AUTO], [SIDE BY SIDE], [TOP AND BOTTOM], or [FRAME SEQUENTIAL] is set, 3D images are not displayed with the [3D
SETTINGS] menu → [3D SIMUL INPUT SETTING]. In [AUTO], this only applies when 3D format can be recognized.
f This may not function properly for some connected external devices.
[LEFT/RIGHT SWAP]
Display images by inverting the timing when the left and right images are swapped. Change the setting when
there is something wrong with the 3D image being viewed.
1)
Press as to select [LEFT/RIGHT SWAP].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[SWAPPED]
Note
f This function is disabled when [3D SYSTEM SETTING] is set to anything other than [SINGLE].
[3D COLOR MATCHING]
Switch the color matching correction data applied to displayed image.
1)
Press as to select [3D COLOR MATCHING].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[SHARED 2D/3D]
[SEPARATE 2D/3D]
Note
f Switch the setting of [COLOR MATCHING] (x page 131) while the signal to be adjusted is being input.
[DARK TIME SETTING]
Set the black display period that is displayed between the right eye image and the left eye image to match the 3D
system in use.
1)
Press as to select [DARK TIME SETTING].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[0.5ms]
[1.0ms]
[1.5ms]
[2.0ms]
[2.5ms]
[2.7ms]
128 - ENGLISH
Chapter 4 Settings — [3D SETTINGS] menu
Forcibly displays 2D images regardless of input image signals.
Forcibly displays 3D images in side by side format regardless of input image signals.
Forcibly displays 3D images in top and bottom format regardless of input image signals.
Forcibly displays 3D images in frame sequential format regardless of input image signals.
*2
Do not change the [NORMAL] setting if the 3D images are displayed correctly.
Select this item when left and right 3D images are swapped to be displayed.
Uses same correction data for 2D signal and 3D signal.
Uses different correction data for 2D signal and 3D signal.
Sets an item so that 3D setting is made correctly.
Advertisement
Table of Contents
