Table of Contents
Advertisement
Precautions for use
Intended use of the product
The purpose of the projector is to project a video signal from imaging equipment or a computer on a screen or
other surface as a still image or moving image.
Installation and handling of the laser product
f This projector is the Class 4 laser product that complies with GB 7247.1－2012. There is a danger of damaging
eyes or skin when exposed to direct light or diffuse reflection light from the projector.
f Assign a person responsible of the laser device when using the projector. The person responsible of laser
device shall be selected from people with sufficient knowledge and experience regarding the handling of the
laser device and prevention of damage by the laser beam.
f The person responsible of laser device shall be trained by Panasonic Connect Co., Ltd. before starting to use
the projector.
f The person responsible of laser device shall set the laser controlled area to prevent operation of the projector by
unrelated person, and take following measures.
g Place a partition around the projector to distinguish with other areas, and clearly notify that it is a laser
controlled area by signs, etc.
g Prohibit entry of unrelated person into the laser controlled area, and install locking mechanism such as
automatic lock in the entrance as necessary.
g When it is necessary for unrelated person to enter the laser controlled area, the person responsible for laser
device shall supervise the action.
f Do not enter within Nominal Ocular Hazard Distance (within Nominal Ocular Hazard Area), refer to "Nominal
Ocular Hazard Distance (GB 7247.1－2012)" (x page 7).
f The projector can be operated with a remote interlock switch to prevent emission of laser beam attached to the
<REMOTE 2 输入> terminal. To use a remote interlock switch, an operation to change the internal setting of the
projector is necessary. Consult your dealer when using a remote interlock switch.
Note
f The customer is required to prepare a remote interlock switch to be attached to the <REMOTE 2 输入> terminal.
f When the setting is changed to use a remote interlock switch, the contact control explained in "<REMOTE 2 输入> terminal"
(x page 301) will be disabled.
Cautions when transporting
f Transport the projector with two or more people. Failure to do so may drop the projector, which may result in
damage or deformation of the projector, or injury.
f When transporting the projector, hold it securely by its bottom and avoid excessive vibration and impact. Failure
to do so may cause a failure due to the damaged internal components.
f Do not transport the projector with the adjustable feet extended. Doing so may damage the adjustable feet.
Cautions when installing
rDo not set up the projector outdoors.
The projector is designed for indoor use only.
rDo not set up the projector in the following locations.
f Places where vibration and impacts occur such as in a car or vehicle: Doing so may cause damage to internal
components or malfunction.
f Location close to sea or where corrosive gas may occur: The projector may fall due to corrosion. Also, failure to
do so may shorten the life of the components and result in malfunctions.
f Near the exhaust of an air conditioner: Depending on the conditions of use, the screen may fluctuate in rare
cases due to the heated air from the exhaust vent or the hot or cooled air from the air conditioner. Make sure
that the exhaust from the projector or other equipment, or the air from the air conditioner does not blow toward
the front of the projector.
f Places with sharp temperature fluctuations such as near lights (studio lamps): Doing so may shorten the life of
the light source, or result in deformation of the projector due to heat, which may cause malfunctions.
Follow the operating environment temperature of the projector.
Chapter 1 Preparation — Precautions for use
ENGLISH - 17
Advertisement
Table of Contents
