Table of Contents
Advertisement
[NATIVE]
[SIMULTANEOUS]
[SIDE BY SIDE]
[TOP AND BOTTOM]
[LINE BY LINE]
*3
[FRAME SEQUENTIAL]
*1 During DVI-D, HDMI, or DIGITAL LINK input only
*2 During 3G-SDI level B input only
*3 Only while signals other than interlaced signals are input
*4 Only while progressive signals with the vertical scanning frequency of 100 Hz or 120 Hz are input to the <RGB1>/<RGB2>/<DVI-D> terminals
4)
Press the <ENTER> button.
Note
f When set to [AUTO], [SIMULTANEOUS], [SIDE BY SIDE], [TOP AND BOTTOM], [LINE BY LINE], or [FRAME SEQUENTIAL], 3D images
are not displayed in [3D SIMUL INPUT SETTING]. In [AUTO], however, this only occurs when 3D format can be recognized.
f This may not function properly for some connected external devices.
[3D 24Hz IMAGE PROJECTION]
(Only for PT-DZ870E)
Set the output frame rate when a 3D signal with the vertical scanning frequency of 24 Hz is input.
1)
Press as to select [3D 24Hz IMAGE PROJECTION].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[144fps]
[96fps]
Note
f This function is enabled only when a 3D signal with the vertical scanning frequency of 24 Hz is input. The [3D 24Hz IMAGE PROJECTION]
setting can be changed even when the corresponding signal is not input.
f When [3D 24Hz IMAGE PROJECTION] is set to [144fps], [SCREEN SETTING] (x page 96) cannot be selected. [SCREEN FORMAT] is
fixed to [16:9] and [SCREEN POSITION] cannot be adjusted. Adjust the image position using [3D 24Hz IMAGE POSITION].
f When [3D 24Hz IMAGE PROJECTION] is set to [144fps], the image may not be displayed correctly if the function of [CUSTOM MASKING]
(x page 84), [EDGE BLENDING] (x page 86), [UNIFORMITY] (x page 103), or [DISPLAY SETTING] (x page 131) is used.
[3D 24Hz IMAGE POSITION]
(Only for PT-DZ870E)
Set the image position when a 3D signal with the vertical scanning frequency of 24 Hz is input.
1)
Press as to select [3D 24Hz IMAGE POSITION].
2)
Press qw to adjust the position.
f Adjust the vertical position between -60 and +60.
Note
f The position can be adjusted only when [3D 24Hz IMAGE PROJECTION] is set to [144fps] and a 3D signal with the vertical scanning
frequency of 24 Hz is input.
[LEFT/RIGHT SWAP]
Display images by inverting the timing of horizontal image switching. Change the settings when there is something wrong with the 3D image
being viewed.
1)
Press as to select [LEFT/RIGHT SWAP].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[SWAPPED]
92 - ENGLISH
Chapter 4 Settings — [3D SETTINGS] menu
Forcibly displays 2D images regardless of input image signals.
Forcibly displays 3D images in simultaneous system regardless of input video signals.
*2
Forcibly displays 3D images in side by side format regardless of input image signals.
Forcibly displays 3D images in top and bottom format regardless of input image signals.
Forcibly displays 3D images in line by line system regardless of input video signals.
Forcibly displays 3D images in frame sequential format regardless of input image signals.
*4
Displays images with the frame rate of 144 fps.
Displays images with the frame rate of 96 fps.
Do not change the [NORMAL] setting if the 3D images are displayed correctly.
Select this when left and right 3D images are swapped to be displayed.
Advertisement
Table of Contents
