Table of Contents
Advertisement
<REMOTE 2 输入> terminal
It is possible to control the projector remotely (by contact control) from a control board located away from the
projector where remote control signals cannot reach.
Use the <REMOTE 2 输入> terminal on the connecting terminals of the projector to connect to the control board.
Installation locations in meeting rooms, etc.
Pin assignments and signal names
Outside view
(6)
(9)
(1)
(5)
Attention
f When controlling, make sure to short-circuit pins (1) and (9).
f When pins (1) and (9) are short-circuited, the following buttons on the control panel and the remote control are disabled. Commands for
RS-232C and network functions corresponding to these functions are also disabled.
g Power on <b> button, power standby <v> button, <快门> button
f When pins (1) and (9) are short-circuited, and then any pins from (3) to (7) and the pin (1) are short-circuited, the following buttons on the
control panel and the remote control are disabled. Commands for RS-232C and network functions corresponding to these functions are also
disabled.
g Power on <b> button, power standby <v> button, <HDMI> button, <DISPLAYPORT> button, <DVI-D> button, <SDI> button, <DIGITAL
LINK> button, <SLOT 1> button, <SLOT> button, <INPUT MENU> button, <快门> button
Note
f To change the settings of pins (2) to (8), set [REMOTE2 MODE] to [USER]. (x page 195)
Chapter 7 Appendix — Technical information
Pin No.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Remote control
Remote control/contact control
Standby
HDMI
SDI
Remote control board in another location
Signal name
GND
POWER
HDMI
DVI-D
SDI
DIGITAL LINK
None
SHUTTER
Controlled by remote
ENABLE / DISABLE
Contact control
Lit
Light source
DVI-D
DIGITAL LINK
Open (H)
Short (L)
—
GND
OFF
ON
Other
HDMI
Other
DVI-D
Other
SDI
Other
DIGITAL LINK
—
—
OFF
ON
Controlled by external
control
contact
ENGLISH - 301
Advertisement
Table of Contents
