Table of Contents
Advertisement
Chapter 3 Basic Operations — Operating with the remote control
Attention
f Since the ID number of the remote control can be set without the projector body, do not press the <ID 设定> button on the remote control
carelessly. If the <ID 设定> button is pressed and no number (<0> - <9>) buttons are pressed within five seconds, the ID number returns to
its original value before the <ID 设定> button was pressed.
f The ID number set on the remote control will be stored unless it is set again. However, it will be erased if the remote control is left with dead
batteries. Set the same ID number again when the batteries are replaced.
Note
f When the ID number of the remote control is set to [0], you can control the projector regardless of the ID number setting of the projector
body, as same as when [ALL] is set.
f Set the ID number of the projector body from the [PROJECTOR SETUP] menu → [PROJECTOR ID].
94 - ENGLISH
Advertisement
Table of Contents
