Installing The Processor Heatsink Module - Supermicro X13SEED-F User Manual

Installing the Processor Heatsink Module

After assembling the Processor Heatsink Module (PHM), install it onto the CPU socket:
1. Align pin 1 of the PHM with the printed triangle on the CPU socket. See the left image
below.
2. Make sure all four holes of the heatsink are aligned with the socket, then gently place
the heatsink on top of the CPU socket.
3. Press all four rotating wires outwards and make sure that the heatsink is securely
latched into the CPU socket.
4. With a T30 Torx-bit screwdriver, gradually tighten the four screws to ensure even
pressure. You can start with any screw, but make sure to tighten the screws in a
diagonal pattern. To avoid damaging the processor or socket, do not use a force greater
than 12 lbf-in when tightening the screws.
5. Examine all corners to ensure that the PHM is firmly attached to the socket.
Printed Triangle
Mount the Processor Heatsink Module
onto the CPU socket (on the motherboard).
Airflow direction
Pin 1
29
Chapter 2: Installation
T30 Torx Screwdriver
Use a torque
of 12 lbf-in
Press the rotating wires outwards to latch
the PHM and then tighten the four screws.