Supermicro X13SEED-F User Manual page 100

Super X13SEED-F/-SF User's Manual
USB Security Policy
Use this feature to configure USB Security Policy settings. When this feature has not
previously been set to Enabled, this feature will toggle whether the BIOS should automatically
save a USB Authentication-Key named "USBAuth.bin" to a USB flash drive and begin the
USB Security Policy. The options are Disabled and Enabled. Changes take effect after you
save settings and reboot the system.
Note: Connect a USB flash drive to your system before configuring this feature. Save
the USB Authentication-Key and keep a backup.
When this feature has been previously set to Enabled, the options are Enabled and Reset.
To disable the USB Security Policy, set this feature to Reset. When this feature is set to reset,
the system and TCG NVMe devices chosen in "Super-Guardians Protection Policy" will be
in the unprotected mode.
Intel(R) I210 Gigabit Fiber Network Connection -
XX:XX:XX:XX:XX:XX
Note 1: This feature is available when "Onboard LAN Option ROM Type" is set to EFI.
Note 2: The Ethernet controller and MAC addresses shown above are based on you
system.
Firmware Image Properties
The following information is displayed:
•
Option ROM Version
•
Unique NVM/EEPROM ID
•
NVM Version
NIC Configuration
Legacy Boot Protocol
Use this feature to select a non-UEFI network boot protocol. The default option is none.
Link Speed
Use this feature to specify a port speed for the selected boot protocol. The options are
Auto Negotiated, 10 Mbps Half, 10 Mbps Full, 100 Mbps Half, 100 Mbps Full.
Wake On LAN
If this feature is set to Enabled, the LAN port will be enabled when the system is powered
on. The options are Disabled and Enabled.
100