Table of Contents
Advertisement
Panasonic Digital Business System - Programming Manual
April 1997
Call logging-printing selection outgoing/incoming
0#:
Outgoing exchange line calls only
1#:
Incoming and outgoing exchange line calls
This specifies whether only outgoing calls are logged or incoming and outgoing calls are logged.
Call logging-printing selection local/long distance calls
0#:
Long distance calls only
1#:
All calls
This specifies whether the call logger records all calls made or long distance calls only.
Call logging-printing with title
0#:
data only
1#:
titles in addition to data
This specifies weither or not to print titles every 60 lines. When only using a printer this will give a
set of titles near the top of each page. If the data is being recorded by a call management system
this step will usually be set for 0# as titles will not normally be required.
Call logging-buffer
000#:
(001-100)#
The DBS will buffer the last 100 calls and send these details out when a call logger is connected. If
no call records are to be lost this buffer can be 'locked' so that when it is full to the preset capacity
no further calls can be made until the saved records have been output. Unless specifically
required this step should be left set to 0# to prevent unexpected system stoppages.
Call logging- Incoming ring time/All lines busy time printing
0#:
No output of incoming ring time, and all lines busy time
1#:
Only incoming Ring Time is output
2#:
Only all lines busy time is output
3#:
Output both incoming ring time and all lines busy time.
This specifies whether the incoming ring time and/or busy time on each exchange line is to be
output to a call logger. The incoming ring time is placed in the dialled number field next to an 'I'
condition code and the all lines busy time is placed in the duration field next to a 'B' condition
code when the first line becomes free.
FF1-2#-2#-7#-(0 or 1)#
FF1-2#-2#-8#-(0 or 1)#
FF1-2#-2#-9#-(0 or 1)#
FF1-2#-2#-10#-(000 - 100)#
No check for overflow, hold last 100 calls only
Prohibit dialling out when buffer fills to the preset capacity
FF1-2#-2#-11#-(0-3)#
[SMDR OUT/INCOME]
[SMDR LONG/LOCAL]
[SMDR TITLE CONT]
[SMDR BUF EMPTY]
[SMDR BUSY/NOANS]
25
Issue 15
2.x
2.x
2.x
2.x
3.1
Advertisement
Table of Contents
