Panasonic DBS Series Programming Manual page 128

Panasonic Digital Business System - Programming Manual
April 1997
Additional programming steps have been added to the call logging parameters to allow
configuration of the new port.
Starting Remote Programming
There are two ways of starting remote programming.
The first method is completely externally using the DISA function and dialling directly to the RAI
card.
The second method is to put the system in hold with the operator's telephone and have the
operator initiate the link to the RAI card.
A) Remote Programming Mode with DISA
After the system has answered the call made to the exchange line specified in the system as
DISA, enter the DISA ID if used and then dial #6 and the remote programming ID. The remote
programming ID is 9999 in default. The system will respond with the opening screen for remote
access.
B) Remote Programming Mode by Attendant's telephone
The incoming call for remote programming is placed on hold by the operator's extension and the
operator dials #6 and the programming ID (9999 default), this will connect to the RAI card and
display the opening screen.
Remote Programming Modes
There are 3 modes for the remote programming. When the opening screen is displayed these
modes can be selected.
INPUT [P]
INPUT [D]
INPUT [CTRL] [Z]
for Programming
for Memory Dump (Hex dump - for engineering use)
Remote Maintenance Complete - Quit
128
Issue 15