Panasonic DBS Series Programming Manual page 129

Panasonic Digital Business System - Programming Manual
April 1997
Effective Number of Digits for Input
When the number of digits input is less than 3, 0 is used to fill out the entry to make it 3 digits
When it is more than 3 digits, the last 3 digits only are taken while the rest are ignored.
1
100
1000
12345
This restriction is common to all the remote programming modes.
Completion of Remote Programming
The remote programming operation is completed by entering [Ctrl] + [Z]. The first time will return
to the top level screen ( or disconnect if already at the top level screen) and the second time will
sign off.
The following situations will also cause the remote programming mode to terminate.
A) When data has not been input for more than 16 minutes.
B) When the outside line is cut off.
Remote Programming Display - Sample
REMT>
Press "P" and Enter key.
(Note : "P" must be input by Capital letter)
*DBS System Programming*
- 0.1 System param
- 0.2 Trunk param
- 0.3 Extension param - 0.8 Copy mode
- 0.4 Ring assignment - 0.9 SPD param
- 0.5 FF key assignment
* Control key*
- B : Back to previous address
- F : Forward to next address
- R : Return to provide mode
- b : Back to previous port
- f: Forward to previous port
Enter Selection Data
Press "- 0.1" and press "ENTER key"
SYSTEM PROGRAM
*System Program Parameters*
1. Calendar 5. ID code set for Program
2. System mode sel
3. Time 7. F.N.P. reference
4. Remote mente
001
=>
=> 100
000
=>
345
=>
- 0.6 Name assignment
- 0.7 TRS param
-.1.0 LCD param
6. F.N.P. Setting
8. DISA ID code setting
129
Issue 15