Panasonic DBS Series Programming Manual page 17

Panasonic Digital Business System - Programming Manual
April 1997
Operator incoming call overflow
0#: No overflow
1 - 15 # : Number of simultaneously ringing calls before overflow.
This specifies the maximum number of incoming, ringing exchange line calls that the operator can
receive simultaneously before the operator incoming call overflow assignment is used. Calls which
are Off Hook Signalling count as ringing.
Note: The same ringing assignment is used for both Operator incoming call overflow and delayed
ringing
Related steps FF4 3#, Operator Overflow / Delayed Ringing Assignment
FF1 2# 1# 26# , Delayed Ringing
Music-on-hold-int/ext selection
0#: Internal MOH
1#: External MOH
This specifies whether internal or external MOH is played to call on hold.
Note: This setting requires a soft reset by switching the system off and back on.
FF1-2#-1#-17# [NOT USED]
FF1-2#-1#-18# [NOT USED]
Transfer deny-(extension)
0#: Enable transfer
1#: Disable transfer
This specifies whether extensions can transfer calls. This does not apply to operator extensions
Nominating telephone to receive un-answered call
[CONF]#: Operator phone rings
1-144#: Nominated extension port number
This specifies which extension to ring with an un-answered call in Night Mode. The nominated port
must be a keyset.
Note: If the Operator extension will need to set call forward this step must be used to nominate
another extension. If there are no key stations which can be used enter a port number that is
not supported by any card E.g. 144
FF1-2#-1#-15#-(00 or 15)#
FF1-2#-1#-16#-(0 or 1)# (P)
FF1-2#-1#-19#-(0 or 1)#
FF1-2#-1#-20#-(1-144)#
17
Issue 15
[ATT. OVERFLOW]
[MOH TONE CHANGE]
[TRANSF SETTING]
[NIGHT RING TEL]
2.x
2.x
2.x
2.x