Organization; Webui Conventions - Juniper SSG 5 Serial Hardware Installation

SSG 5 Hardware Installation and Configuration Guide

Organization

WebUI Conventions

6
Organization
This guide contains the following sections:
Chapter 1, "Hardware Overview," describes the chassis and components for an
SSG 5 device.
Chapter 2, "Installing and Connecting the Device," describes how to mount an
SSG 5 device and how to connect it to your network.
Chapter 3, "Configuring the Device," describes how to configure and manage
an SSG 5 device and how to perform some basic configuration tasks.
Chapter 4, "Servicing the Device," describes service and maintenance
procedures for the SSG 5 device.
Appendix A, "Specifications," provides general system specifications for the
SSG 5 device.
Appendix B, "Initial Configuration Wizard," provides detailed information
about using the Initial Configuration Wizard (ICW) for an SSG 5 device.
To perform a task with the WebUI, you first navigate to the appropriate dialog box,
where you then define objects and set parameters. A chevron ( > ) shows the
navigational sequence through the WebUI, which you follow by clicking menu
options and links. The set of instructions for each task is divided into navigational
path and configuration settings.
The following figure lists the path to the address configuration dialog box with the
following sample configuration settings:
Objects > Addresses > List > New: Enter the following, then click OK:
Address Name: addr_1
IP Address/Domain Name:
IP/Netmask: (select), 10.2.2.5/32
Zone: Untrust