Aux Port; Back Panel; Power Adapter - Juniper SSG 5 Serial Hardware Installation

Back Panel

NOTE:

Power Adapter

AUX Port

The auxiliary (AUX) port is an RJ-45 serial port wired as data terminal equipment
(DTE) that can be connected to a modem to allow remote administration. We do not
recommend using this port for regular remote administration. The AUX port is
typically assigned to be the backup serial interface. The baud rate is adjustable from
9600 bps to 115200 bps and requires hardware flow control. Use a straight-through
cable when connecting to a modem and a crossover cable when connecting to
another DTE device.
See "Connectors" on page 47 for the RJ-45 connector pinouts.
This section describes the following elements on the back panel of an SSG 5 device:
Power Adapter
Radio Transceiver
Grounding Lug
Antennae Types
USB Port
Only the SSG 5-WLAN devices have the antennae connectors.
Figure 5: Back Panel of an SSG 5 Device
Antenna B
Grounding
lug
DC POWER
B
5V 4 A
Power
adapter
The POWER LED on the front panel of a device either glows green or is off. Green
indicates correct function, and off indicates power-adapter failure or that the device
is off.
USB host
module
L OCK
USB
SD F L ASH RESET A
Reset
pinhole
Antenna A
13
Back Panel