Modem Interface - Juniper SSG 5 Serial Hardware Installation

SSG 5 Hardware Installation and Configuration Guide
V.92 Modem Interface
NOTE:
38
WAN Configuration
The V.92 interface provides an internal analog modem to establish a PPP
connection to a service provider. You can configure the serial interface as a primary
or backup interface, which is used in case of interface failover.
The V.92 interface does not work in Transparent mode.
To configure the V.92 interface, use the WebUI or CLI:
WebUI
Network > Interfaces > List > Edit (for serial0/0): Enter the following, then
click OK:
Zone Name: untrust (select)
ISP: Enter the following, then click OK:
ISP Name: isp_juniper
Primary Number: 1234567
Login Name: juniper
Login Password: juniper
Modem: Enter the following, then click OK:
Modem Name: mod1
Init String: AT&FS7=255S32=6
Active Modem setting
Inactivity Timeout: 20
CLI
set interface serial0/0 zone untrust
set interface serial0/0 modem isp isp_juniper account login juniper password
juniper
set interface serial0/0 modem isp isp_juniper primary-number 1234567
set interface serial0/0 modem idle-time 20
set interface serial0/0 modem settings mod1 init-strings AT&FS7=255S32=6
set interface serial0/0 modem settings mod1 active
For information on how to configure the V.92 modem interface, refer to the
Concepts & Examples ScreenOS Reference Guide.