Juniper SSG 5 Serial Hardware Installation page 42

SSG 5 Hardware Installation and Configuration Guide
42
Upgrading Memory
4. Use a phillips screwdriver to remove the screws from the memory-card cover.
Keep the screws nearby for use when securing the cover later.
5. Remove the memory-card cover.
Figure 13: Bottom of Device
6. Release the 128 MB DIMM DRAM by pressing your thumbs outward on the
locking tabs on each side of the module so that the tabs move away from the
module.
Figure 14: Unlocking the Memory Module
7. Grip the long edge of the memory module and slide it out. Set it aside.