Using The Webui - Juniper SSG 5 Serial Hardware Installation

Using the WebUI

NOTE:
3. Launch a serial terminal-emulation program on your workstation. The required
settings to launch a console session are as follows:
Baud rate: 9600
Parity: None
Data bits: 8
Stop bit: 1
Flow Control: None
4. If you have not yet changed the default username and password, enter
at both the login and password prompts. (Use lowercase letters only.
netscreen
The login and password fields are both case-sensitive.)
For information on how to configure the device with the CLI commands, refer
to the Concepts & Examples ScreenOS Reference Guide.
5. (Optional) By default, the console times out and terminates automatically after
10 minutes of idle time. To remove the timeout, enter set console timeout 0 .
To use the WebUI, the workstation from which you are managing the device must
initially be on the same subnetwork as the device. To access the device with the
WebUI, perform the following steps:
1. Connect your workstation to the 0/2 — 0/6 port (bgroup0 interface in the Trust
zone) on the device.
2. Ensure that your workstation is configured for Dynamic Host Configuration
Protocol (DHCP) or is statically configured with an IP address in the
192.168.1.0/24 subnet.
3. Launch your browser, enter the IP address for the bgroup0 interface (the default
IP address is 192.168.1.1/24), then press Enter.
When the device is accessed through the WebUI the first time, the Initial
Configuration Wizard (ICW) appears. If you decide to use the ICW to configure
your device, see "Initial Configuration Wizard" on page 49.
The WebUI application displays the login prompt as shown in Figure 11.
25
Accessing a Device