Specifications
Type: 72 inch (1.8 m) width of cut, 3 blades.
Height Of Cut: 1 to 5 inches (25 to 127 mm) adjustable
in 1/2 inch (13 mm) increments. Front adjustment is with
snapper pin and grooves in castor shaft. Rear adjust
ment is with hanger brackets and pin.
Construction: Housing is made of 12 gauge steel and
reinforced with 2–1/2 inch x 10 gauge angle.
Cutter Drive: Gear box mounted on cutting unit is driven
by PTO shaft. Power is transmitted to the blades by one
hex B section belt. Spindle shafts are 1–1/4 inch (32
mm) diameter and supported by two externally sealed,
greaseable, tapered roller bearings.
Blades: Three 25.18 in. (716 mm) long, .25 in. (6 mm)
thick, heat–treated steel. Patent Pending.
Specifications and design subject to change without notice.
72 inch Cutting Units
Suspension & Castor Wheels: Two front castors, con
sisting of 10 in. (254 mm) pneumatic wheel and tire as
sembly with sealed ball bearings. Rear of deck is
suspended from lift arms with adjustable deck rake. Hy
draulic counter balance and lift system designed inte
gral with deck for maximum flotation.
Anti–scalp Features: Anti–scalp cup located on each
blade. Two gauge wheels. Adjustable skid on each end
of deck.
Deck Covers: 16 gauge steel covers.
Quick Attach System: Tapered joint with over center
adjustable tensioning latch.
Weight: Rear Discharge 545 lbs. (247 Kg). Guardian
Recycler 555 lbs. (252 Kg).
Page 11 – 2
Rev. A
Groundsmaster 3000/3000–D