Toro Groundsmaster 3000 Service Manual page 28

Groundsmaster 3000 Maintenance Schedule
Minimum Recommended Maintenance Intervals
Maintenance Procedure
Lubricate All Grease Fittings
Inspect Air Filter
Check Battery Level/Cable Connections
Check Cutting Unit Gearbox Oil Level
Clean Under Cutting Unit Belt Covers
Check Cutting Unit Drive Belt Adjustment
Change Engine Oil and Filter
Inspect Cooling System Hoses
Check Fan, Governor and Alternator Belt Tension
Torque Wheel Lug Nuts
Check Governor Oil Level
Service Spark Arrester Muffler
Service Air Filter
Change Fuel Filter
Inspect Fuel Lines and Connections
Change Spark Plugs
Check Engine RPM (idle and full throttle)
Torque Head and Adjust Valves
Change Cutting Unit Gearbox Oil
Change Hydraulic Oil
Change Hydraulic Oil Filter
Drain and Clean Fuel Tank
Pack Rear Axle Bearings
Check Rear Wheel Toe–In
Initial break in at 10 hours
Initial break in at 50 hours
Initial break in at 200 hours
Replace Moving Hoses
Replace Safety Switches
Cooling System Flush/Replace Fluid
(See Operator's Manual for specifications and procedures.)
Product Records and Maintenance
Maintenance Interval & Service
Every
Every
100hrs
50hrs
A Level
Service
B Level
Service
C Level
Service
Annual Recommendations:
Items listed are recommended every 1500
hours or 2 years, whichever occurs first.
Page 2 – 10
Every
Every
400hrs
200hrs
D Level
Service
Groundsmaster 3000/3000–D
Every
800hrs
E Level
Service