Transport Solenoid
(GM 3000–D)
The transport solenoid is located below the seat and on
the front right side of the hydraulic housing.
Note: Prior to taking small resistance readings with a
digital multimeter, short the test leads together. The me
ter will display a small resistance value (usually 0.5
ohms or less). This resistance is due to the internal re
sistance of the meter and test leads. Subtract this value
from from the measured value of the component you are
testing.
1. Make sure engine is off. Disconnect solenoid elec
trical connector.
2. Apply 12 VDC source directly to the solenoid. Listen
for solenoid to switch on.
3. Measure resistance between the two connector ter
minals. The resistance should be about 9.0 ohms.
Glow Plugs
(GM 3000–D)
The glow plugs are located on the top of the cylinder
block and on the right side of the engine. They are con
nected in parallel with black wires to an orange lead wire
(Fig. 40).
Note: Prior to taking small resistance readings with a
digital multimeter, short the test leads together. The me
ter will display a small resistance value (usually 0.5
ohms or less). This resistance is due to the internal re
sistance of the meter and test leads. Subtract this value
from from the measured value of the component you are
testing.
1. Disconnect black wire from the glow plug.
2. Using a digital multimeter, connect one lead to the
post of the terminal and connect the other to the cylinder
block near the plug.
3. The resistance should be about 0.6 to 1.5 ohms.
Groundsmaster 3000/3000–D
GLOW PLUGS
Page 6 – 23
Rev. A
Figure 39
GLOW PLUGS
Figure 40
Figure 41
Electrical System