Adjustments
Transport Latch Adjustment
1. Start tractor and raise deck to highest possible posi
tion and turn off engine.
2. Loosen (2) flange head capscrews securing latch
plate to side of gearbox.
3. Rotate latch rod downward from front of traction
unit.
4. Insert latch rod into rear hole (transport position) in
latch plate.
5. Rotate front of deck upward and insert latch rod into
front hole (service position) in latch plate.
6. Loosen latch plate flange head capscrews and ad
just latch plate position if required.
7. Tighten flange head capscrews securing latch plate
to gearbox.
8. Remove hair pin cotters and clevis pins securing
height–of–cut chains to rear of deck.
9. Remove latch rod from rear hole in latch plate.
Groundsmaster 3000/3000–D
2
1
2
1
(Guardian Recycler)
Page 11 – 3
Figure 2
(Rear Discharge)
1. Latch Plate
2. Latch Rod
Figure 3
1. Latch Plate
2. Latch Rod
72 inch Cutting Units