Skid Adjustment; Anti-Scalp Roller Adjustment - Toro Groundsmaster 3000 Service Manual

Skid Adjustment

Skids should be located in upper holes for 1 (25 mm) and
1–1/2 inch (38 mm) heights–of–cut and lower holes for 2
(51 mm) to 5 inch (127 mm) heights–of–cut.
1. Adjust skids by removing flange nuts, positioning as
desired and re–installing flange nuts.
Anti–Scalp Roller Adjustment
Anti–scalp rollers should be located in upper holes for 1
(25 mm) and 1–1/2 inch (38 mm) heights–of–cut and
lower holes for 2 (51 mm) to 5 inch (127 mm) heights–
of–cut. Five rollers are located on the deck, three under
the main deck and one on each wing.
1. Adjust anti–scalp rollers by removing lock nut and
bolt, positioning as desired and reinstalling lock nut and
bolt.
Groundsmaster 3000/3000–D
1
Page 9 – 5
Figure 6
1. Skid
Figure 7
1. Anti–scalp roller
84 inch Cutting Units
1