Service and Repairs
CAUTION
To prevent accidental starting of the engine,
while performing maintenance, shut engine off
and remove key from ignition switch.
Grease Bearings and Bushings
The cutting unit must be lubricated regularly. If machine
is operated under normal conditions, lubricate castor
bearings and bushings with No. 2 general purpose lithi -
um base grease or molybdenum base grease, after ev-
ery 50 hours of operation. Lubricate fittings immediately
after every washing, regardless of the interval listed.
Groundsmaster 3000/3000–D
1. The cutting unit has (19) bearings and bushings that
must be lubricated, and these lubrication points are:
front castor shaft bushings (5), chamber pivots (12) and
right and left push arm ball joints (2).
Figure 9
Page 10 – 7
Contour 82 Cutting Unit