Omron V320-F Series Connection Manual page 73

9.6.4. Step Settings
The step settings for communications sequence No.900 are shown below. The step settings
include Retry, Send Message and Recv Message (message names), Next, and Error. The
sequence in the protocol macro data consists of Step No. 00 only.
Note
For details on the step settings, refer to 3-3 Step Attributes in the CX-Protocol Operation
Manual (Cat. No. W344).
● Retry Count Setting
The Retry setting for the step is shown below. If an error occurs, the protocol macro will
retry the step the specified number of times (0 to 9 times). If the error persists even after the
retries, it will go to Error Processing.
The retry count is valid only for the Send & Receive command.
Step Setting Screen
Settings
Step
00
● Send/Receive Message (Message Name) Settings
The Send Message and Recv Message settings for the step are shown below. The send
message name and receive message name that are separately registered are set.
Step Setting Screen
Settings
Step
00
Retry
3
Send Message
SD_RDCODE
Recv Message
RV_RDCODE
9. Program
70