11
The Advanced Settings Screen
appears.
Select the Communications
Tab and check that the settings
are as follows.
[RS232A]
Baud Rate: 9600
Parity: None
Stop Bits: 1
Data Length: 8
[Host Protocol]
Protocol
Point-to-Point
[Preamble]
Preamble: Disabled
Postamble
Postamble: Enabled
Postamble
<CR><LF>
12
Click on the icon shown in the
red frame to save the settings to
the code reader.
13
Finally,
check
number of the code reader.
Click on the gear icon on the
upper right of the screen and
select About WebLink.
Selection:
Characters:
the
version
7. Connection Procedure
20