Omron V320-F Series Connection Manual page 14

5. Applicable Devices and Support Tools
Precautions for Correct Use
Ensure that the CX-Programmer and CX-Protocol are updated to the versions specified in
this section or higher. If you use a version other than the version specified in this section,
there may be differences in the procedures in Section 7 and later. In that case, refer to the
CX-Programmer Operation Manual (Cat. No. W446) or CX-Protocol Operation Manual (Cat.
No. W344) to perform the equivalent procedures.
Note
The configuration may not be reproduced if the system component models or versions differ.
Check your configuration and, if there is any difference in the models or versions, contact
OMRON.
Note
This document assumes that the USB is used to connect the PLC. For information on how to
install the USB driver, refer to the CX-Programmer Operation Manual (Cat. No. W446).
Note
Refer to the Industrial Switching Hub W4S1 Series User Manual (0969584-7) for power
supply specifications that can be used for 24 VDC power supply (for the switching hub).
Note
Refer to the MicroHAWK V320-F/V330-F/V420-F/V430-F Series Barcode Reader User
Manual (Cat. No. Z432) for the power supply specifications that can be used for 24 VDC
power supply (for the code reader).
11