Omron V320-F Series Connection Manual page 41

In the Change PLC Dialog Box,
5
confirm that USB is selected in
Network Type, and click OK.
* If USB is not selected in
Network Type, select USB
from the pull-down menu.
Select Connect to PLC from the
6
PLC Menu.
Confirm that the operating mode
7
indication of the PLC icon in the
project workspace has changed
from Offline to Program, which
means that the CX-Protocol is
online with the PLC.
* If the indication is Monitor or
Run, perform steps 8 to 9
below to change to Program.
If the operating mode indication
8
of the PLC is Monitor or Run,
select Operating
Program from the PLC Menu.
A dialog box as shown in the
9
figure on the right appears. Click
Yes.
Confirm that the mode indication
has changed to Program, as
described in step 7.
Double-click New Protocol List
10
in the project workspace to open
the tree.
Mode –
7. Connection Procedure
38