Omron V320-F Series Connection Manual page 37

7.3.5. Transferring the Project Data
Transfer the project data to the PLC.
In the CX-Programmer, select
1
Programs
in
workspace, and select Transfer
– To PLC from the PLC Menu.
Select the check boxes for
2
Program(s), Comments, and
Program index, and click the
OK Button.
* Do not select IO table and
Special Unit Setup since you
have set these data in 7.3.3.
and 7.3.4.
* Comments and Program
index may not be shown
depending on the PLC model.
If so, transfer the project data
with only
selected.
A dialog box as shown in the
3
figure on the right appears. Click
Yes.
the project
Program(s)
7. Connection Procedure
34