Omron V320-F Series Connection Manual page 47

7.4.2. Executing the Program
Execute the program in the CX-Programmer.
In the CX-Programmer, open the
1
tree structure under Programs
in the project workspace, and
double-click Section1.
In the Ladder Section Window,
the ladder diagram for Section1
is displayed.
This document uses a barcode
2
as shown in the right figure as
an example of reading.
Set the code reader to the
position where it can read the
barcode in the right figure.
In the Ladder Section Window,
3
right-click Input_Start and select
set/reset – set from the menu.
* Any contact is acceptable as
long as it is Input_Start. (In the
figure on the right, you are
operating the
contact in Block 0.)
Input_Start
7. Connection Procedure
Ladder Section Window
44