7.3.3.
Creating the I/O Table
Create the I/O table for the PLC.
If the PLC Operating Mode is set
1
to either Run or Monitor, follow
steps (1) to (3) to change it to
Program.
(1)
In
the
CX-Programmer,
select Operating Mode –
Program from the PLC Menu.
(2) A dialog box as shown in the
figure on the right appears.
Click Yes.
For information on how the
dialog box is displayed, refer
to Note on the previous page.
(3) Confirm that Program Mode
is displayed to the right of the
PLC
model
CX-Programmer's
tree. (See the figure on the
right.)
in
the
project
7. Connection Procedure
27