Typical Configuration Problems - Nortel 2000 User Manual

Book B
Typical Configuration Problems
The syntax for disabling several modules is:
set annex disabled_modules lat,snmp,ppp,slip
You should exercise extreme caution when disabling modules:
• If disabled_modules is set to a value other than none and
server_capability includes the operational image, no
modules are disabled; a syslog message announces this
override.
• The vci option disables the Annex interface for VMS
environments along with the following commands:
backwards, change, clear, crash, define, disconnect,
forwardlis, forward, list, logout, resume, set, show.
• If lat_key is invalid and server_capability is set to none, the
LAT code is freed for use by the system.
• Disabling LAT also disables the CLI commands services,
connect, and queue.
• Disabling admin and snmp can cause problems if host-based
na is not available. To change parameters in this case, return
to monitor mode, erase the parameters in non-volatile
memory, and reconfigure the Annex.
Each Annex hardware platform provides a hardware installation guide
that contains troubleshooting information. Many problems that occur
after an Annex is running are due to improper configuration of the Annex
or a host. The following subsections describe the symptoms of several
common configuration problems.
Remote Annex Administrator's Guide for UNIX
Chapter 1 Network Administration
Book B-37