Task 3: Create Static Routes To End-User Systems - Paradyne 8540 Network Configuration Manual

Network Configuration Worksheets

TASK 3: Create Static Routes to End-User Systems

A-20
NOTE:
Perform this task only if you are assigning IP addresses to the end-user
systems statically. If you are planning to assign addresses dynamically, skip
to Task 5: Define DHCP Relay Features to Enable Dynamic IP Address
Configuration .
On the Static Routes screen, create a static route to end-user systems on each
DSL card. For host addressing, fill out one worksheet for each end-user system.
For structured subnet addressing, complete up to 16 worksheets (up to four
worksheets for each of the DSL ports corresponding to the four domains
supported on each port).
NOTE:
Each time you create a static route for an end-user system behind an RTU,
you should also create a corresponding source-based input filter rule. See
Chapter 7, IP Filtering
Worksheets , for introductory information about the filtering screens. See the
HotWire DSLAM for 8540 and 8546 DSL Cards User's Guide for detailed
information.
Access the . . .
Static Routes screen
November 1997
, and Appendix B, IP Filtering Configuration
By . . .
Selecting Configuration
Routes from the HotWire – DSL menu.
IP Router Static
8000-A2-GB21-20