Paradyne 8540 Network Configuration Manual page 109

IP Filtering Configuration Worksheets
B-2
NOTE:
In this release, you can configure up to two filters on the MCC card and
up to eight filters on each DSL card. Also, up to 33 rules can be
configured for each filter. Keep in mind that for each filter, you will need to
configure the default filter action (either to forward or discard packets).
For each DSL card, the HotWire DSLAM provides the following default
filter names:
— lan1 – bound to e1a
— dsl1 – bound to DSL port #1
— dsl2 – bound to DSL port #2
— dsl3 – bound to DSL port #3
— dsl4 – bound to DSL port #4
For the MCC card, lan1 (bound to e1a) is the only default filter.
When using these filter names as input filters, by default, these filters are
already bound to their corresponding interfaces. To use these filter
names as output filters, you must manually bind them on the IP Network
screen.
November 1997 8000-A2-GB21-20