Service Domain Configuration Worksheets - Paradyne 8540 Network Configuration Manual

Network Configuration Worksheets

Service Domain Configuration Worksheets

A-16
For the service domain, select the DSL card you want to configure, and then
configure the following for each of the DSL cards in the HotWire DSLAM:
Perform this task . . .
1. Assign IP addresses to
the DSL card LAN
interface (e1a).
(See page A-17.)
2. Reset the DSL card.
(See page A-19.)
Perform the following tasks only if assigning addresses statically
3. Create static routes to
end-user systems on
each DSL card.
(See page A-20.)
4. Create default route or a
source route.
(See page A-22.)
Perform the following task only if assigning addresses dynamically
5. Define DHCP relay
features to enable
dynamic IP address
configuration.
(See page A-24.)
Use the worksheets in the following sections to record your network configuration
settings. Photocopy the worksheets as needed.
November 1997
On this screen . . .
(HotWire – DSL)
IP Network
(HotWire – DSL)
Card Reset
(HotWire – DSL)
Static Routes
(HotWire – DSL)
Static Routes
(HotWire – DSL)
DHCP Relay
To access the screen . . .
From the HotWire – DSL
menu, select:
Configuration Interfaces
IP Network
From the HotWire – DSL
menu, select:
Configuration Card
Status Card Reset
From the HotWire – DSL
menu, select:
Configuration IP
Router Static Routes
From the HotWire – DSL
menu, select:
Configuration IP
Router Static Routes
From the HotWire – DSL
menu, select:
Configuration DHCP
Relay
8000-A2-GB21-20