Configure Initial Card Parameters Using The Cli; Nortel Integrated Conference Bridge: Service Implementation Fundamentals; Nn43001-558/555-4001-135 01.02 Standard - Nortel 2100 Fundamentals

The next step is to define IP parameters using the CLI.
Procedure 13
Configure initial card parameters using the CLI
Step
1
2
3
4
5
6
7
Nortel Communication Server 1000/Communication Server 2100 Solution/Meridian SL-100

Nortel Integrated Conference Bridge: Service Implementation Fundamentals

Copyright © 2007, Nortel Networks
.
•
Stop bit: 1
• Parity: No
• Flow control: none
Note: Do not use XON/XFF flow control.
Action
Enter the key-code.
Enter the card feature (Basic or Advanced).
From the VT-100 type terminal press the Enter key.
The logon window appears.
At the login prompt, enter the following:
admin
Where "admin" is the default administrator password.
Access the System Administration menu. Enter:
SA
The System Administration menu opens.
Access the System Attributes Editor. Enter:
SY
The System Attributes Editor opens.
Enter the following IP attributes for the ICB card:
• IP address - The internet protocol address which has the same
format as the gateway address.
•
Subnet mask - The part of the IP address which represents a
subnetwork within a network. The subnet mask has a format of
XXX.XXX.XXX. XXX, where XXX is in the range 0-255. Subnet
mask in binary presentation of 32 bits has at least the first eight
digits "1" and the last digit is "0".

NN43001-558/555-4001-135 01.02 Standard

ICB Release 4 20 June 2007
ICB installation and configuration procedures 73
—End—