Configure Media Card 32-Port And Itg-Pentium 24-Port Trunk Cards And Units For Ip Trunk Route - Nortel 1000 Fundamentals

ABTR (15) Range 0-30
VTRK (NO)YES
NODE <Node ID>
IFC SL1
If the DTI and PRI2 packages are restricted and the VTRK prompt is set
to NO, SCH2160 is printed on the TTY and VTRK is reprompted. Only
PRI/PRI2 is supported for 911P routes, and if DTI and PRI2 packages are
restricted, VTRK should not be set to NO.
Configure Media Card 32-port and ITG-Pentium 24-port trunk cards and
units for IP Trunk Route
Use LD 14 to configure the Media Card 32-port and ITG-Pentium 24-port
trunk cards and units. Record the first CHID for each IP trunk card on the IP
Trunk 3.01 (and later) Installation Summary Sheet.
LD 14 Configure Media Card 32-port and ITG-Pentium 24-port trunk cards and units
Prompt Response
req
NEW/CHG/OUT
REQ NEW XX
TYPE TIE
TN XX XX
l s c u
Copyright © 2007, Nortel Networks
.
Configure IP Trunk 3.01 (and later) data 227
Timer (in minutes) blocks the disconnect from being
tandemed across to the target node. Default value: 15
minutes. This timer value can be added in increments of
1 minute.
YES = supports IP Peer facilities.
Node ID associated with the Signalling Server dedicated
for 911P trunks.
IFC is set to SL1 by default if M911P is set to YES. This
prompt is not configurable.
Description
Add new data, where:
xx = 1 – 24 for ITG-Pentium 24-port trunk card
xx = 1 – 32 for Media Card 32-port trunk card
When using REQ = NEW XX, configure only one IP trunk
card at a time.
When using REQ = NEW XX, CHID is incremented for
each of the new units created.
It might be necessary to configure partial IP trunk cards due
to WAN traffic capacity limitations, or Leader and DCHIP
card real-time capacity for very large nodes and networks.
Terminal number
Format for Large System, Call Server 1000E, and Media
Gateway 1000E, where l = loop, s = shelf, c = card, u = unit
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007