Nortel 1000 Configuration Manual page 63

Configuring the dialing plan for PSTN access to SRG users in Normal Mode 63
Prompt Response
...
- RLI 0-999
Configuring the dialing plan using CS 1000 Element Manager
From Element Manager, configure the branch office–specific zone dialing
plan and Access Codes. From the navigator, select IP Network >
Zones. From the Zones window in Element Manager, select the Branch
Office Dialing Plan and Access Codes option, and enter the necessary
information. See
64).
Copyright © 2005-2007, Nortel Networks
.
Description
Route List Index configured in LD 86 (see step 1)
After configuring the specialized route for calls that have been routed
to the branch office by the NRS, the route must be associated with
the ESN Special Number.
The branch office receives the manipulated number as an incoming
call, indicating that the ZDP value added at the main office is at the
beginning of the number. The branch office ESN configuration must
ensure that the extra digits (the ZDP value) are deleted by using a
proper DMI. The call then terminates at the PSTN connection.
The DMI configured in LD 86 in step 1 is used to remove the digits that
were inserted in the dialed number at the main office.
For example, assume ZDP at the main office = 101, Customer
number = 0, and the RLI for the PSTN trunk = 18.
LD > 90
REQ NEW
CUST 0
FEAT NET
TRAN AC1
TYPE SPN
SPN 1011
FLEN 0
...
RLI 18
Figure 12 "Zone Dialing Plan and Access Codes" (page
Nortel Communication Server 1000
Main Office Configuration Guide for SRG 50
NN43001-307 02.02 Standard
Release 5.0 3 December 2007
ATTENTION
—End—