Nortel 1000 Configuration Manual page 192

192 Emergency Services configuration
Configuring ESA for the branch office
For ESA, the main office Call Server forwards the call to the branch office
for termination. Calls are redirected over a Virtual Trunk using the NRS. The
NRS routes the calls using a special number, referred to in this section
as the ESA Special Number.
ESA must be configured and tested on the main office Call Server and the
SRG to differentiate between emergency calls originating from IP Phones at
each location and calls originating on trunks, which refers to the forwarded
emergency call that the SRG receives from the main office for an IP Phone
in Normal Mode.
Use the following steps to configure ESA for emergency access at each
location:
At the main office:
Step
1
2
3
4
5
6
7
8
9
10
Copyright © 2005-2007, Nortel Networks
.
Action
Determine the dialing plan (for example, numbering plan) for ESA
calls.
Configure the main office emergency trunk (CAMA or PRI).
For EMEA, the following trunks are supported:
• BRIE (Basic Rate Interface–ETSI based)
• PRI (Primary Rate Interface per EURO ISDN)
•
QSIG on PRI
• DPNSS
•
IP tandem trunks on ISDN
Configure the Virtual Trunk at the main office.
Configure ESN at the main office.
Configure ESA at the main office.
Configure the SRG zone on the main office.
Configure a zone for each branch office which is used in conjunction
with ESA parameters to route an emergency call to the SRG.
Test ESDN using a main office telephone.
Configure the SRG emergency trunk (CAMA or PRI).
Configure the Virtual Trunk at the MG 1000B.
Configure ESN at the branch office.
Nortel Communication Server 1000
Main Office Configuration Guide for SRG 50
NN43001-307 02.02 Standard
Release 5.0 3 December 2007