Configuring Pppoe Tunneling Protocol - Nortel Secure 4134 Configuration

192 PPPoE client configuration
Procedure steps
Step
1
2
3
Table 97
Variable definitions
Variable
address <ip-address/m
ask>
negotiated
Configuring PPPoE tunneling protocol
Configure the PPPoE tunneling protocol. The only available option in this
release is client mode (the default).
Procedure steps
Step
1
2
3
Copyright © 2007, Nortel Networks
.
Action
To enter configuration mode, enter:
configure terminal
To specify the name of the PPPoE interface to configure, enter:
interface virtual-access <pppoe-interface>
To specify the IP address for this interface, enter:
{address <ip-address/mask> | negotiated }
Value
Specifies the IP address for the interface.
Specifies that the IP address for the interface is
obtained via PPP IPCP (IP Control Protocol) address
negotiation with the PPPoE server.
Action
To enter configuration mode, enter:
configure terminal
To specify the name of the PPPoE interface to configure, enter:
interface virtual-access <pppoe-interface>
To specify the IP address for this interface, enter:
protocol pppoe pppoe-mode [client]
Nortel Secure Router 4134
Security — Configuration and Management
NN47263-600 01.02 Standard
10.0 3 August 2007
—End—
—End—