Enabling Or Disabling The Ipsec Policy Entry; Specifying The Ip Stream On Which To Apply Ipsec - Nortel Secure 4134 Configuration

130 IPsec VPN configuration
4

Enabling or disabling the IPsec policy entry

Enable or disable the IPsec policy entry.
Procedure steps
Step
1
2
3
4

Specifying the IP stream on which to apply IPsec

Specify the IP stream on which to apply IPsec.
When this command is entered, a default proposal is created, with the
following properties: priority 1, ESP, 3DES, SHA1, DH-group2, tunnel mode.
Procedure steps
Step
1
2
3
Copyright © 2007, Nortel Networks
.
To enable or disable anti-replay, enter:
[no] anti-replay
Action
To enter the configuration mode, enter:
configure terminal
To specify crypto configuration for IPsec and IKE, enter:
crypto
To specify the IPsec policy to configure, enter:
ipsec policy <policy-name> <peer-gateway-ip>
To enable or disable the IPsec policy, enter:
[no] enable
Action
To enter the configuration mode, enter:
configure terminal
To specify crypto configuration for IPsec and IKE, enter:
crypto
To specify the IPsec policy to configure, enter:
ipsec policy <policy-name> <peer-gateway-ip>
Nortel Secure Router 4134
Security — Configuration and Management
NN47263-600 01.02 Standard
10.0 3 August 2007
—End—
—End—