Timezone Option; Table 21 Time Command Options; Table 22 Timezone Command Options - Nortel BayStack 100-S Reference

58 Chapter 2 Using configuration commands
Table 21

Table 21 time command options

Option
hhmm
timezone
Example
ii> time 1904
Wed Aug 9 19:04:00 2000
ii> time cst6cdt
Wed Aug 9 19:04:00 2000

timezone option

The
display the current setting of the timezone option, use the
stdoffset[dst[offset][,rule]]
Table 22

Table 22 timezone command options

Option
std,dst
302005-F
describes the
time
Definition
Sets the time in hours followed by minutes.
See "timezone option" on page 58
option for the
timezone
describes the
timezone
Definition
Three or more letters that are the designation for the standard (
or daylight saving time
omitted, then summer time
Note the following:
• Uppercase and lowercase letters are allowed.
• Any characters are allowed, except for the following: a leading
colon (:), digits, comma (,), minus (-), plus (+), and ASCII NUL (\0).
command options.
command sets the system time zone. To
time
command options.
zone. Only std is required. If dst is
(dst)
(dst) does not apply in this locale.
for more information.
command.
config
std )