Nortel BayStack 100-S Reference page 73

Table 31 webproxy command options (continued)
Option
activetime
activeend
activedays
address
binpercent
bintime
bypass
cgi
Reference for the BayStack Instant Internet Remote Access Commands Version 7.11
Chapter 2 Using configuration commands
Definition
Sets the number of minutes from midnight that you want to start the
active refresh.
(default: 460 (8:00 AM))
minutes - number of minutes from start time to stop the Active
Refresh.
Sets the number of minutes from the start time to stop the active
refresh.
(default: 540 (5:00 PM))
Specifies the days of the week that the active refresh will run.
(default: 62 (Monday through Friday))
bitmap - the bit map of the days to run the Active Refresh.
Bit 1=Sunday, 2=Monday . . . 7=Saturday.
Sets the address of an HTTP proxy. This command redirects HTTP
requests through another proxy (for additional filtering, caching, and
so forth.). Specifying an illegal URL disables using the proxy.
Sets the percentage of the current date Instant Internet should use
when calculating a binary Web entry's expiration. When an entry
stored in the cache has no expiration time stamp, Instant Internet
calculates the expiration time based on a percentage of the current
date and time minus the entry's last modified date and time.
(default: 40%. Note: This default value is based on the
set to <2>.)
percent - the expiry percent for the binary.
Specifies the minimum number of minutes a binary Web entry with no
expiration time can be expired before it is checked against the original
Web server.
(default: 20 minutes. Note: This default value is based on the
option set to <2>.)
- the actual minimum number.
time
Enables or disables the use of the Web cache. When on, no searching
or caching of results occur. This option takes precedence over all other
caching options.
Enables or disables the caching of CGI entries.
(default: on. Note: This default value is based on the
set to <2>.)
73
option
level
level
option
level