Table of Contents
Advertisement
56. Remove (4) Phillips head screws shown in
Figure 50 to remove ON/OFF switch cover.
57. Loosen strain relief shown in Figure 50.
Figure 50. Location of ON/OFF switch cover and
motor cord strain relief.
58. Attach ON/OFF switch box to switch panel
with (1) M4-.7 x 20 button head cap screw,
#10 flat washer, and M4-.7 hex nut (see
Figure 51).
Note: Switch can be installed on either left or
right side of switch panel.
ON/OFF
Switch
Box
Left Position
Mounting
Holes
Figure 51. ON/OFF switch attached to switch
panel (shown installed on right side of panel).
Model G0960 (Mfd. Since 09/22)
x 4
Motor Cord
Strain Relief
59. Insert motor cord through empty strain relief
on ON/OFF switch box.
60. Use remaining M4-.7 x 20 button head cap
screw, #10 flat washer, and M4-.7 hex nut to
attach ON/OFF switch box to switch panel
and ground both green wires against switch
box (see Figure 52).
Both ground wires MUST be secured with
same grounding screw to be grounded
correctly to reduce risk of electric shock.
61. Connect black motor wire to A1 terminal of
ON/OFF switch (see Figure 52).
62. Connect white motor wire to A3 terminal of
ON/OFF switch (see Figure 52).
Ground
Wire
(1 of 2)
White Motor Wire
Figure 52. Motor cord wires correctly connected.
63. Tighten ON/OFF switch box strain relief, then
install switch box cover with screws removed
in Step 56.
Black
Motor Wire
-29-
Advertisement
Table of Contents
