Grizzly G0960 Owner's Manual page 26

28. Attach cable pulley to right rear post with (1)
M12-1.75 x 110 hex bolt,
19 x 19.5mm spacer, and M12-1.75 hex nut
(see Figure 31).
Figure 31. Cable pulley attached to right rear
post.
29. Thread blade height handle into blade height
crank of lift assembly, as shown in Figure 32.
30. Remove hex nut shown in Figure 32 in order
to remove (2) cable pulleys, (4) flat washers,
spacer, and hex bolt from lift assembly.
Blade
Height
Handle
Figure 32. Blade height handle installed in blade
height crank and location of hex nut to remove
from lift assembly.
-24-
⁄ " flat washer, 12 x
1
2
Lift Assembly
Blade Height
Crank
31. Have assistant hold lift assembly while you
attach it to rear left post with (1) M10-1.5 x 80
hex bolt, (2) ⁄ " flat washers, and (1) M10-1.5
3
8
hex nut (see Figure 33).
32. Attach lift assembly to switch panel with (2)
M8-1.25 x 20 hex bolts and
(see Figure 33).
x 2
Figure 33. Lift assembly attached to carriage.
33. Attach lift assembly to rear left post with hex
bolt, spacer, flat washers, cable pulleys, and
hex nut removed in Step 30 (see Figure 34).
Figure 34. Stationary cable pulleys installed on
lift assembly.
Model G0960 (Mfd. Since 09/22)
⁄ " flat washers
5
16