Table of Contents
Advertisement
To adjust blade guide assemblies:
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen blade guide assembly adjustment
screw (see Figure 72) so you can slide blade
guide assembly forward and backward.
Blade
Guides
Figure 72. Location of blade guide assembly
and adjustment screw.
3.
Adjust blade guide assembly until there is
about 0.016" between front of blade guide
and blade gullets (see Figure 73).
/
" or 0.016"
1
64
Blade
Gullets
Figure 73. Blade guide positioned 0.016" behind
blade gullets.
4.
Tighten blade guide assembly adjustment
screw to secure.
5.
Repeat Steps 2–4 on second blade guide
assembly.
-40-
Blade Guide
Assembly
Adjustment Screw
Blade Guide
Assembly
Blade
Guide
Adjusting Blade Support Bearings
When properly adjusted, there is about 0.040"
between the blade support bearings and the
blade.
Items Needed
Feeler Gauge 1mm (0.040") .............................. 1
Hex Wrench 3mm .............................................. 1
To adjust blade support bearings:
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen support bearing adjustment screw on
blade guide (see Figure 71) so you can slide
bearing forward and backward.
Support Bearing
Adjustment Screw
Support
Bearing
Figure 74. Location of support bearing and
adjustment screw.
3.
Adjust support bearing until there is about
0.040" between front of support bearing and
back of blade (see Figure 75).
Figure 75. Support bearing positioned 0.040"
behind back of blade.
Model G0960 (Mfd. Since 09/22)
Qty
Back of Blade
/
" or 0.040"
3
64
Support Bearing
Advertisement
Table of Contents
