Grizzly G0960 Owner's Manual page 30

Note: Carriage must face forward for log sup-
ports and log clamps to function (see Figure
46). Log clamps are attached to front rail
section.
Right
Blade Cover
Lock Knob
Figure 46. Carriage placed on track and location
of right blade cover and lock knob.
48. Confirm that all carriage leg wheels are
aligned with rails, then tighten all carriage
fasteners. Take extra care to tighten cable
clamps so they do not come loose once saw
head is lifted.
49. Turn right blade cover lock knob clockwise to
open right blade cover (see Figure 46).
50. Attach 4" dust port to right blade cover with
(4) M5-.8 x 10 button head cap screws and
M5-.8 hex nuts (see Figure 47).
4" Dust Port
Figure 47. 4" dust port attached to right blade
cover.
-28-
Right
Blade Cover
Log Clamp
(1 of 2)
x 4
51. Close right blade cover and secure with lock
knob.
52. Attach square dust port to saw head with (4)
M6-1 x 10 hex bolts and 6.4 x 16 x 1.2mm flat
washers (see Figure 48).
53. Attach square dust port cover to square
dust port with (2) M6-1 x 10 hex bolts (see
Figure 48).
x 2
Square Dust
Port Cover
Figure 48. Square dust port and cover attached
to saw head.
54. Remove (1) nut from strain relief, then use
nut to install strain relief on switch panel as
shown in Figure 49.
55. Insert motor cord through strain relief on
switch panel (see Figure 49).
Strain
Relief
Motor
Cord
Figure 49. Motor cord inserted through switch
panel strain relief.
Model G0960 (Mfd. Since 09/22)
x 4
Square
Dust
Port