Terminal Module Tm31 - Siemens SIMOTION D4 Series Manual

Supplementary system components

6.5 Terminal module TM31

Data

Switching frequency of the outputs, max.



Maximum lamp load
Short-circuit protection
Data for: Vcc = 24 V; load 48 Ohm; H = 90% V
1)
The digital inputs are protected against polarity reversal up to -30 V
2)
The values were not available at the time for going to press. Current information is
3)
available at: (http://support.automation.siemens.com/WW/view/en/27585482)
6.5 Terminal module TM31
Properties of the TM31
With the TM31 terminal module, the number of available digital inputs/digital outputs and the
number of analog input/analog outputs within a drive system can be expanded. The TM31 is
connected via DRIVE-CLiQ. It has two DRIVE-CLiQ interfaces for this.
The TM31 contains the following terminals:
Table 6- 28
Interface
Digital inputs
Bidirectional inputs/outputs
Relay outputs with changeover contact
Analog inputs
Analog outputs
Temperature sensor input (KTY84-130 or PTC)
The 50 mm clearances above and below the components must be observed.
106
Output delay, typ./max. (hardware)
With resistive load
With inductive load
With lamp load
Interface overview
CAUTION
SIMOTION CX32-2
L -> H: 150 µs / 400 µs
1)
H -> L: 75 µs / 100 µs
100 Hz
2 Hz
11 Hz
5 W
Yes
, L = 10% V
out
Quantity
8
4
2
2
2
1
out
SIMOTION D4x5-2
Manual, 11/2010